Category: Maintenance

The switch was clearly worn as I had to jiggle it to get it to locate properly. So I replaced it with a new one.

Replaced starboard steering cable. The port side was replaced a few years ago. So other than the bit that goes around the steering quadrant – all new.

Painting coming to a conclusion… launch tomorrow.

Paint Scrape and sand took two people 3 x 6 hr days. Additional time to prep. and then on to painting. Survey Spent 3 hrs on Merva with a surveyor. Went very well. Very little to do.

Merva on the hard at Jacks Yard. The hull has been pressure washed. It shows the following paint layers; red, green, red, and black. The last two layers were not sticking to the boat as they should but that is not too surprising as I asked for a quick job. Some speculation about how the…

Final preparations for 3 weeks out. Looks all dressed up!

While the wood finish on the exterior is varnish – the interior is a mix of oil and varnish. I am slowly moving the interior to 100% varnish. I did a bit of this in the wheel house today.

I decided to fetch the louver panels from the mezzanine in the boathouse and install them. It would appear that they have not been installed in a long time as I had to install supporting bits first. Tossed 4 cans of fuel into the port side. Seems to have leveled out across starboard so no…